| Magniflux and Inspect Block |
$90.00 |
| Thermal Clean Block |
$90.00 |
| Electrolytic Cleaning (rust removal) |
$160.00 |
| Deck Block 3 Sides (heads and intake) |
$150.00 |
| Bore & Power Hone Block to 3 5/16 (0.125 OS) |
$195.00 |
| Sleeve One Cylinder (+ Sleeve) |
$100.00 |
| Sleeve Each Additional Cylinder (+ Sleeve) |
$85.00 |
| Index and Pin Main Caps |
$90.00 |
| Align Bore Mains |
$135.00 |
| Align Hone Mains |
$84.00 |
| Fit 4 Bolt ctr main cap, index, pin and hone all mains |
$260.00 |
| Crankshaft; modify oil galleys, drill & tap cleanouts
& install new plugs |
$195.00 |
| Wet Magniflux (crank) |
$65.00 |
| Grind Crank Only |
$125.00 |
| Recondition 8 Rods, Fit Pins, Bushings and Nuts |
$280.00 |
| Install Cam Bearings |
$45.00 |
| Drill and Hone Block for Adj. Lifters |
$45.00 |
| Modify Block for Full Flow Oil Filter |
$75.00 |
| Mild Port Polish & Relieve Block, 1.5" valves |
$595.00 |
| Mild Port Polish & Relieve Block, 1.6" valves |
$795.00 |
| 3 Angle Cut on Valve Seats |
$128.00 |
| Machine & Install Hardened Valve Seat (1) |
$45.00 |
| Machine 8 Exhaust Seats |
$120.00 |
| Machine 8 Intake Seats |
$120.00 |
| Drill & Tap Water Pump Shaft for Grease Fitting |
$45.00 |
| Full Engine Balance |
$195.00 |
| Disassemble Engine |
$200.00 |
| Engine Assembly |
$675.00 |
| Run in of Engine, adjust fuel & ignition system
& re-torque fasteners |
$360.00 |
| Crack Repair (1 inch) |
$55.00 |
Last modified:
September 16, 2003